ZyXEL Communications P-870HN-51B - V1.0 Manual page 74

Chapter 5 WAN Setup
Note: When a layer-2 interface is in VLAN MUX Mode or MSC Mode, you can
configure up to eight WAN services for each interface.
Figure 31 Internet Connection
The following table describes the labels in this screen.
Table 12 Internet Connection
LABEL
Interface
Description
Type
Rate
Vlan8021p
VlanMuxId
ConnId
74
DESCRIPTION
This shows the name of the interface used by this connection.
A default name ipoa*, pppoa*, atm* or ptm* indicates DSL port.
The pppx name (where x starts from 0 and is the index number of
PPP connection on the ZyXEL Device) indicates a PPP connection via
any one of the WAN interface.
The number after the dot (.) represents the VLAN ID number assigned
to traffic sent through this connection. The number after the
underscore (_) represents the index number of connections through
the same interface.
(null) means the entry is not valid.
This is the service name of this connection.
0 and 35 or 0 and 1 are the default VPI and VCI numbers. The last
number represents the index number of connections over the same
PVC or the VLAN ID number assigned to traffic sent through this
connection.
(null) means the entry is not valid.
This shows the method of encapsulation used by this connection.
This shows the maximum data rate (in Kbps) allowed for traffic sent
through this connection. This displays N/A when there is no limit on
transmission rate.
This indicates the 802.1P priority level assigned to traffic sent through
this connection. This displays N/A when there is no priority level
assigned.
This indicates the VLAN ID number assigned to traffic sent through
this connection. This displays N/A when there is no VLAN ID number
assigned.
This shows the index number of each connection. This displays N/A
when the interface used by the connection is in Default Mode.
P-870HN-51b User's Guide