Various Functions Of This Fax; Sending 2-Sided Documents (Duplex Transmission) - Kyocera KM-1650 Operation Manual

3

Various Functions of this Fax

Sending 2-Sided Documents (Duplex Transmission)

Duplex Transmission enables the transmission of
both the front and back sides of duplex (2-sided)
documents when the optional Document Processor
is installed. Duplex transmission is always
accomplished by setting the documents you want
to transmit in the Document Processor and
scanning them into memory in the Memory
Transmission mode. It is also possible to use
Duplex Transmission capabilities in combination
with each of the other various types of fax
communication available in this fax. The following
method explains the procedure for sending duplex
documents to a single destination.
Notes
•
•
•
•
1
Set the 2-sided documents in the Document Processor.
2 Open the cover plate to the left and press the Duplex
Tx. key.
The letter D will be displayed in the first line of the
message display to indicate this is a duplex
transmission.
You can cancel a Duplex Transmission by simply
pressing the Duplex Tx. key again.
To enable Duplex Transmission, you must select Standard size original when setting
the document size for scanning from the Document Feeder. Duplex Transmission will not be
available if the document size is set to Long original. (See Setting the Document Size for
Scanning from the Document Processor ("Scan from DP" setting) on page 7-10.)
If you press the Duplex Tx. key during any operation, Dial Confirmation for one-touch keys will
not be available. It will also be necessary to press the Start key in order to initiate dialing for
abbreviated numbers and one-touch keys.
In order to schedule a start time for the transmission, press the Delayed Tx. key at any point in
the procedure PRIOR to entering the destination fax number.
If you want to cancel the procedure part way through, press the Reset key. The operation panel
will return to the initial mode settings.
3-1