Ospf Interface Settings - D-Link DGS-3324SRi User Manual

To add an OSPF Area to the table, type a unique Area ID (see below) select the Type from the drop-down menu. For a
Stub type, choose Enabled or Disabled from the Stub Import Summary LSA drop-down menu and determine the Stub
Default Cost. Click the Add/Modify button to add the area ID set to the table.
To remove an Area ID configuration set, simply click
To change an existing set in the list, type the Area ID of the set you want to change, make the changes and click the
Add/Modify button. The modified OSPF area ID will appear in the table.
See the parameter descriptions below for information on the OSPF Area ID Settings.
The Area ID settings are as follows:
Parameter
Area ID
Type
Stub Import
Summary LSA
Stub Default Cost

OSPF Interface Settings

To set up OSPF interfaces, click Configuration > Layer 3 IP Networking > OSPF > OSPF Interface Settings to view
OSPF settings for existing IP interfaces. If there are no IP interfaces configured (besides the default System interface), only
the System interface settings will appear listed. To change settings for in IP interface, click on the hyperlinked name of the
interface to see the configuration menu for that interface.
xStack Stackable Gigabit Layer 3 Switch Manual
Figure 6- 123. OSPF Area Settings example window
Description
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
This field can be toggled between Normal and Stub using the space bar. When it is
toggled to Stub, additional fields appear
Default Cost.
Displays whether or not the selected Area will allow Summary Link-State
Advertisements (Summary LSAs) to be imported into the area from other areas.
Displays the default cost for the route to the stub of between 0 and 65,535. The default
is 1.
Figure 6- 124. OSPF Interface Settings window
in the Delete column for the configuration.
Stub Import Summary LSA, and the Stub
185