Authentication Policy & Parameters - D-Link DGS-3324SRi User Manual

Switch will then go to the next technique listed in the server group for authentication, until the authentication has been
verified or denied, or the list is exhausted.
Please note that users granted access to the Switch will be granted normal user privileges on the Switch. To gain access to
administrator level privileges, the user must access the Enable Admi n window and then enter a password, which was
previously configured by the administrator of the Switch.
Authentication Policy & Parameters
This command will enable an administrator-defined authentication policy for users trying to access the Switch. When
enabled, the device will check the Login Method List and choose a technique for user authentication upon login.
To access the following window, click Security Management > Access Authentication Control > Authentication
Policy & Parameter Settings:
Figure 7- 6. Authentication Policy and Parameter Settings window
The following parameters can be set:
Parameters
Authentication Policy
Response Timeout (0-
255)
User Attempts (1-255)
Click Apply to implement changes made.
xStack Stackable Gigabit Layer 3 Switch Manual
NOTE: TACACS, XTACACS and TACACS+ are separate entities and are
not compatible. The Switch and the server must be configured exactly the
same, using the same protocol. (For example, if the Switch is set up for
TACACS authentication, so must be the host server.)
Description
Use the pull down menu to enable or disable the Authentication Policy on the
Switch.
This field will set the time the Switch will wait for a response of authentication from
the user. The user may set a time between 0 and 255 seconds. The default set-
ting is 30 seconds.
This command will configure the maximum number of times the Switch will accept
authentication attempts. Users failing to be authenticated after the set amount of
attempts will be denied access to the Switch and will be locked out of further
authentication attempts. Command line interface users will have to wait 60
seconds before another authentication attempt. TELNET and web users will be
disconnected from the Switch. The user may set the number of attempts from 1 to
255. The default setting is 3.
212