Snmp Host Table - D-Link DGS-3324SRi User Manual

View Name
Access Right
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the
the Delete heading, corresponding to the entry you wish to delete.

SNMP Host Table

Use the SNMP Host Table to set up SNMP trap recipients.
Open the SNMP Manager folder and click on the SNMP Host Table link. This will open the SNMP Host Table page, as
shown below.
To delete an existing SNMP Host Table entry, click the corresponding
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host
IP Address heading.
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the page.
This will open the SNMP Host Table Configuration page, as shown below.
The following parameters can set:
Parameter
Host IP Address
xStack Stackable Gigabit Layer 3 Switch Manual
Type an alphanumeric string of up to 32 characters that is used to identify the group
of MIB objects that a remote SNMP manager is allowed to access on the Switch. The
view name must exist in the SNMP View Table.
Read Only - Specifies that SNMP community members using the community string
created can only read the contents of the MIBs on the Switch.
Read Write - Specifies that SNMP community members using the community string
created can read from, and write to the contents of the MIBs on the Switch.
Figure 7- 28. SNMP Host Table
Figure 7- 29. SNMP Host Table Configuration window
Description
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
under the Delete heading.
238
under