Ospf Interface Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Translate
Stub Summary
Metric (0-65535)
Click the Apply button to accept the changes made.
Click the View Detail link to view a display of the OSPF Area settings.
Click the Edit button to re-configure the selected entry.
Click the Delete button to remove the selected entry.
After click the View Detail
This window is used to display the OSPF Area settings.
Click the <<Back button to return to the previous window.

OSPF Interface Settings

This window is used to configure the OSPF Interface settings for this Switch.
To view the following window, click L3 Features > OSPF > OSPFv2 > OSPF Interface Settings, as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to find the interface entered.
Click the View All button to view all the interfaces configured on this switch.
Click the Edit button to re-configure the selected entry.
After clicking the Edit button, the following window will appear.
Use the drop-down menu to enable or disable the translating of Type-7 LSAs into
Type-5 LSAs, so that they can be distributed outside of the NSSA. The default is
Disabled. This field can only be configured if NSSA is chosen in the Type field.
Set whether or not the selected Area will allow Summary Link-State Advertisements
(Summary LSAs) to be imported into the area from other areas.
Enter the metric (1 - 65535; 0 for auto cost) of this area. For NSSA areas, the metric
field determines the cost of traffic entering the NSSA area.
link, the following window will appear.
Figure 6-44 OSPF Area Settings - View Detail window
Figure 6-45 OSPF Interface Settings window
Description
Enter the name of the IP interface here
226