Config Firmware Image; Compactflash Services - D-Link DGS-3324SRi User Manual

User

Config Firmware Image

The Config Firmware Image window allows users to configure firmware images saved in the memory of the Switch. To
access the following window, click Maintenance > MULTIPLE IMAGE Services > Config Firmware Image.
This window offers the following information:
Parameter
Image
Action
Click Apply to implement changes made.

CompactFlash Services

At the rear of the DGS-3324SRi Switch only, there is an open slot for a CompactFlash card. This 32MB PCMCIA flash
card provides high capacity solid-state flash memory for storing information for and from the Switch, such as firmware,
configuration files and even save log information kept on the Switch. It also supports True IDE Mode that is electrically
compatible with an IDE disk drive. It is recommended that the user store a backup of the startup configuration file and
firmware runtime image on the CompactFlash card of the control module and on a central server.
To install the CompactFlash card, insert it into the available slot on the back of the Switch, as shown below, and ensure
that the card "clicks" into place. When correctly inserted, the CF Card Button should protrude. To eject the card from the
slot, press the CF Card button in and the CompactFlash card should pop out.
xStack Stackable Gigabit Layer 3 Switch Manual
T - If the IP address has this letter attached t o it, it denotes a firmware
upgrade through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware
upgrade through the Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware
upgrade through the web-based management interface.
SIM – If the IP address has this letter attached to it, it denotes a firmware
upgrade through the Single IP Management feature.
States the user who downloaded the firmware. This field may read "Anonymous" or
"Unknown" for users that are not identified.
Figure 10- 6. Config Firmware Image window
Description
Select the firmware image to be configured using the pull-down menu. The Switch
allows two firmware images to be stored in the Switch's memory.
This field has two options for configuration.
Delete – Select this option to delete the firmware image specified in the
Image field above.
Boot – Select this option to set the firmware image specified above as the
boot up firmware for the Switch. This firmware will be set as the boot up
firmware after a switch reboot has been performed. The default setting has
firmware image ID 1 as the boot up firmware image for the Switch unless
specified here.
287