SNTP Settings
Time Settings
To configure the time settings for the Switch, open the Configuration folder, then the SNTP folder and click on the Time
Settings link, revealing the following screen for the user to configure.
The following parameters can be set or are displayed:
Parameter
System Boot Time
Current Time
Time Source
SNTP State
SNTP Primary Server
SNTP Secondary
Server
xStack Stackable Gigabit Layer 3 Switch Manual
Figure 6- 56. Current Time Settings window
Description
Time Settings - Current Time
Displays the time when the Switch was initially started for this session.
Displays the current time.
Displays the source of the time settings viewed here.
Use this pull-down menu to Enable or Disable SNTP.
The IP address of the primary server the SNTP information will be taken from.
The IP address of the secondary server the SNTP information will be taken from.
SNTP Settings
114