Default Settings For Lldp; Configuring Lldp; Enabling Or Disabling Lldp Globally - Cisco Nexus 9000 Series Configuration Manual

Configuring LLDP

Default Settings for LLDP

This table lists the LLDP default settings.
Parameters
Global LLDP
LLDP on interfaces
LLDP hold time (before discarding)
LLDP reinitialization delay
LLDP timer (packet update frequency)
LLDP TLVs
LLDP receive
LLDP transmit
Configuring LLDP
Cisco NX-OS commands for this feature may differ from Cisco IOS commands for a similar feature.
Note

Enabling or Disabling LLDP Globally

You can enable or disable LLDP globally on a device. You must enable LLDP globally to allow a device to
send and receive LLDP packets.
Procedure
Step 1
Step 2
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
[no] feature lldp
Example:
switch(config)# feature lldp
Cisco Nexus 9000 Series NX-OS System Management Configuration Guide, Release 6.x
Default Settings for LLDP
Default
Disabled
Enabled, after LLDP is enabled globally
120 seconds
2 seconds
30 seconds
Enabled
Enabled, after LLDP is enabled globally
Enabled, after LLDP is enabled globally
Purpose
Enters global configuration mode.
Enables or disables LLDP on the device. LLDP
is disabled by default.
211