Overview Screen - Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual

Overview Screen

3-4

Overview Screen

Each button represents
one loop. Click the button
to display the Tuning
screen for the loop.
40
The monitoring process will be started and the Overview Screen will be dis-
played (Refer to 3-4 Overview Screen).
Note a) Steps 2 and 3, above, will not be required and the Overview
Screen will be displayed immediately if auto-starting has been
specified by setting the Auto-start–Auto-start setting to Enable.
b) To finish using CX-Process Monitor while in Operator mode, click
the Close Button in the top right of the Overview Screen, and the
monitor process will automatically end. In Engineer mode, click
the Close Button in the top right of the Overview Screen. If the
monitor process is running, a dialog box will be displayed to con-
firm whether the monitor process should be ended or not. Select
Yes to end the monitor process. Select No to continue running the
monitor process.
The Overview Screen displays all the menu screens and displays alarms.
Click this button to move to the Control screen
The button icons for the registered Control Screen, Trend Screen, Graphic
Screen, and Annunciator Screen will be displayed.
Section 3-4
If a user-set error
occurs, the button for
the Annunciator
screen will flash.