FinsGateway Settings when Connected Using Controller Link
4. Click the Local Node Button, and then click the Next Button.
Enter fields (1) to (5) as shown above. The procedure is shown below.
Before making the settings, check that nothing is entered in column (5). If there is an entry in the
column, make sure to click the Delete Button and delete everything.
1) Set the Area 1 type to DM. Set the Start Word to 20.
2) Set the Area 2 type to CIO. Area 2 is not used in monitoring, but make sure that the settings for
Area 1 and Area 2 are different.
3) Enter the node to be refreshed.
4) Enter the node to be refreshed.
• Set the number of words in Area 1 to 636, and set the Offset to 0.
• Set the number of words in Area 2 to 0, and set the Offset to 0.
• Click the Add Button. This will add Node 1 to the list. To continue, add Node 2 to the list.
• Set the number of words in Area 1 to 636, and set the Offset to 0.
• Set the number of words in Area 2 to 0, and set the Offset to 0.
• Click the Add Button. This will add Node 2 to the list.
5) Check that in Node 1 and Node 2's Area 1, the number of words is set to 636 and the Offset is set
to 0.
5. Click the Next Button to proceed to the next step.
170
1)
4)
3)
Appendix B
2)
5)