System Monitor Settings - Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual

System Monitor Settings

Setup Dialog Box
4-4

System Monitor Settings

86
change to Engineer mode. Refer to 4-3-3 Password Settings above for how
to set the password.
2. Enter the password, and click the OK Button.
The Setup Dialog Box will be displayed.
3. Click any button, and then select a function.
Sets auto-start, tuning
trend scale display,
multi-screen, label
information, alarm sound
information, and ten-key.
Refer to 4-7 System
Information Settings for
details.
1. Sets the System
Monitor Screen. Refer to
4-4 System Monitor
Settings for details.
Refer to the following sections for details on the functions of each button.
Using the System Monitor Setting Window, register the PLC and Loop Control
Unit to be monitored using the System Monitor Screen. Also register the local
computer to perform the monitoring.
The setting items are as follows:
PLC node number (address)
PLC setting g
Loop Control Unit address
Computer setting p g
Computer node number (default is 32)
Communications type (CLK, Serial, Ethernet) (Use the
System Monitor Screen to set CLK or Ethernet
communications.)
For serial connections, you must also set the COM port and
baud rate.
With serial (Host Link) communications only, when you start the Monitor Process
(i.e., select Start Up in the Setup Dialog Box), FinsGateway communications
will start according to the communications conditions given below that have
been set.
• Communications type: Serial (Host Link)
• COM port used and baud rate
Note The PLC settings (node address, Unit address, etc.) set here can be
used only from the System Monitor Screen. Actual communications
processing depends on the network address, node address, and Unit
address set using the CX-Process Tool. Controller Link and Ethernet
settings within the computer settings made here can also be used
only from the System Monitor Screen. Perform actual communica-
tions processing by manually starting FinsGateway.
Section 4-4
2. Opens the Graphic
Screen Create Window.
Refer to 4-5 Graphic
Screen Creation for
details.
3. Configures the screen.
Refer to 4-6 Screen
Configuration for details.
Use the System Monitor y
Screen for this setting. S f hi i