Basic Configuration Operations; Setup Dialog Box - Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual

Basic Configuration Operations

1, 2, 3...
1, 2, 3...

4-3-4 Setup Dialog Box

1, 2, 3...
1. If you do not set a password, when you click the Set Up Button in the Mode
Selection Dialog Box, the following dialog box will be displayed.
2. Click the OK Button.
The following dialog box will be displayed.
3. Enter the password, and click the OK Button.
The following dialog box will be displayed.
4. Enter the password once again, and click the OK Button.
Note If you have forgotten the password or want to change the password, perform the
following operation using the Registry Editor, and after deleting the PassWord
key, set the password once again using the above procedure.
1. Select Start, then select Run, enter regedt32, and then click the OK Button.
The Registry Editor will start.
2. On the local machine, select HKEY_LOCAL_MACHINE, SOFTWARE,
OMRON, CX-Process Monitor, 2.00, and then delete the password.
This section explains the functions of the Setup Dialog Box.
1. In the Mode Selection Dialog Box, click the Set Up Button. The input pass-
word box will be displayed. If you have not set a password, you cannot
Section 4-3
85