Omron WS02-LCTC1-E - V2.60 REV 12-2003 Manual page 25

CX-Process Monitor
Item
Connecting
Connection with CPU Unit
method
(or Serial Communications
Board/Unit)
Connection via Controller
Link
Connection via Ethernet
Loop Control Unit data specification
method
Data exchange method with CPU Unit g
mounted on Loop Control Unit d L C l U i
Offline operation functions
14
Using The computer is connected to the CPU Unit peripheral ports
FinsGateway or integrated RS-232C port, or RS-232C port of the Serial
Serial Unit Communications Unit. (Only a 1:1 connection is possible.)
version
– Connector cable:
When connecting to the CPU Unit peripheral ports: Model
CS1W-CNjjj (2 m, 6 m)
When connecting to the CPU Unit's RS-232C port: Model
XW2Zjjj-j (2 m, 5 m)
– Communications protocol with PLC: Host Link (not
supported on Peripheral bus)
Using Install the driver in a computer equipped with a Controller Link
FinsGateway Support Board (PCI slot) to support communications between
CLK (PCI) the computer and PLCs equipped with a Controller Link Unit.
Driver
Using Install the driver in a computer equipped with a Controller Link
FinsGateway Support Board (ISA slot) to support communications between
Controller the computer and PLCs equipped with a Controller Link Unit.
Link driver
Using Install the FinsGateway ETN_UNIT driver on the computer on
FinsGateway which an Ethernet board is mounted to enable to enable
ETN_UNIT communications with the PLC on which the Ethernet Unit is
driver mounted.
Function blocks, analog signals and contact signals (including parameters)
that are designated as the source by the Send to Computer blocks (Block
Models 401 to 404) are appended a tag name by the CX-Process Tool.
Specify this tag name to specify the Loop Control Unit data.
Mode name
On-demand read CX-Process Monitor reads
mode: the data in the terminal to
computer send area
whenever necessary.
Data Link mode: CX-Process Monitor reads
the terminal to computer
send area at all times by
the Controller Link data
link.
Prepare the user configuration screen for use in the online operation screen.
Descriptions
Description Connection method
One of Host Link, Ethernet
or Controller Link
Only Controller Link is
possible
Section 1-1