User Constant Tables; A: Setup Settings - Omron VARISPEED G7 Instruction Manual

User Constant Tables

A: Setup Settings

The following settings are made with the environment constants (A constants): Language displayed on the
Digital Operator, access level, control method, initialization of constants.
Initialize Mode: A1
User constants for the environment modes are shown in the following table.
Con-
stant
Number
Language
selection for
Digital
Operator
display
A1-00
Select Lan-
guage
Constant
access level
A1-01
Access
Level
Control
method
selection
A1-02
Control
Method
-8
5
Name
Description
Display
Used to select the language
displayed on the Digital
Operator (LCD).
0: English
1: Japanese
2: German
3: French
4: Italian
5: Spanish
6: Portuguese
This constant is not initialized
by the initialize operation.
Used to set the constant
access level (set/read.)
0: Monitoring only
(Monitoring drive mode
and setting A1-01 and A1-
04.)
1: Used to select user
constant
(Only constants set in A2-
01 to A2-32 can be read
and set.)
2: Advanced
(Constants can be read
and set in both quick
programming mode and
advanced programming
(A) mode.)
Used to select the control
method for the Inverter
0: V/f control
1: V/f with PG feedback
2: Open-loop vector control
1
3: Flux vector
4: Open-loop vector control
2
This constant is not initialized
by the initialize operation.
Change
during
Setting Factory
Range Setting
Opera-
V/f
tion
0 to 6 1 Yes A
0 to 2 2 Yes A
0 to 4 2 No Q
Control Methods
MEMO
Open Open
BUS
V/f Loop Flux Loop
Regis-
with Vec- Vec- Vec-
ter
PG tor tor tor
1 2
A A A A 100H
A A A A 101H
Q Q Q Q 102H
Page
-
6-
139
6-
141
4-5
4-7
4-16