Omron V600 User Manual page 87

EXPANSION BATCH FILL (fl)
This command writes specified data for the number of write bytes starting from the specified write start
address. Up to 2 Kbytes of data can be written in a batch.
Command
Processing
area
Write area
Command
Data
number
start address
code
setting setting
× ×
f l H 1
2 1 1
Data setting Always H.
Processing area number Always 1.
setting
Write area start address Specifies the start address of the area in the Data Carrier to be written to in 4-digit hexadecimal
code.
Setting range: 0000h to 1FFFh
Number of write bytes Specifies the data to be written to the Data Carrier in 4-digit hexadecimal.
Setting range: 0001h to 0800h
Specified data Indicates the data to be written to the Data Carrier.
Response
Command
code End code Terminator
f l 0 0 CR
2 2 2
End code Indicates the execution result for the command.
The end code 00 indicates normal completion.
For details on end codes, refer to End code List.
Number of
write bytes
× ×
× × × ×
4 4
p.95
Specified
Terminator
data
× ×
CR
2 2
Section 3
Commands
RFID System
85
User's Manual