Omron V600 User Manual page 37

Setting the Hand-held Reader Writer
•Settings
The following settings are used to operate the Hand-held Reader Writer.
•Serial communications parameters (data transfer speed, parity check, stop bits).
•Basic function settings (Auto Command OFF and Normal Operation Output functions)
These settings can be changed by using a setting command from the host device. To operate the
Hand-held Reader Writer with the new setting, the power must be turned OFF then ON again, or the
ABORT command must be used.
Serial Communications Parameters
The following are the settings related to serial communications. Use the COMMUNICATIONS CONDI-
TIONS SETTING (TR) command.
Item
Baud rate (bps) 2400, 4,800, 9,600 (see note), 19,200, 38,400
Transmission code 7-unit ASCII 7* (see note) or 8-unit JIS 8
Parity check Even parity* (see note)/odd parity/none
Stop bits 2* (see note)/1
Note: Items marked by an asterisk (*) are set as the default when shipped from the factory.
Basic Function Settings
The Auto Command OFF and Normal Operation Output functions can be set. Use the BASIC FUNC-
TIONS SETTING (FN) command
Item
Auto Command OFF Yes (1 minute)*, No
function
Normal Operation No*, Yes
Output function
Note: Items marked by an asterisk (*) are set as the default when shipped from the factory.
•Reading the Settings
Use the SET INFORMATION READ (UL) command to read the settings of the Hand-held Reader
Writer. The information read by the SET INFORMATION READ command is set in the backup memory
of the Hand-held Reader Writer. For this reason, care must be taken when the power is first turned ON
after the settings have been changed because the operational settings of the Hand-held Reader Writer
will be different.
•Initializing the Settings
A setting command is used to set the Hand-held Reader Writer but if the communications parameters
are not known or if the setting contents are damaged, it is possible that communications will no longer
be possible with the host device. If this occurs, press both the reset button and the activate switch
when turning ON the power. This will return all settings to the defaults set when the Hand-held Reader
Writer was shipped from the factory, allowing communications with the host device again.
Communications Preparations
Contents
Contents
Section 2
RFID System
35
User's Manual