Omron TJ2-MC64 - PROGRAMMING Programming Manual page 131

BASIC commands
/i
Value Input device
0 Programming port 0
1 RS-232C serial port 1
2 RS-422A/485 serial port 2
5 Trajexia Studio port 0 user channel 5
6 Trajexia Studio port 0 user channel 6
7 Trajexia Studio port 0 user channel 7
/i
• vr_variable
The first VR variable to write to.
Example Consider the following line in a program.
LINPUT#5, VR(0)
Entering START<CR> on port 5 will give
VR(0)=83 ' ASCII 'S'
VR(1)=84 ' ASCII 'T'
VR(2)=65 ' ASCII 'A'
VR(3)=82 ' ASCII 'R'
VR(4)=84 ' ASCII 'T'
VR(5)=13 ' ASCII carriage return
See also GET, INPUT, VR
3.2.179 LIST
/i
Type Program command (Trajexia Studio command line only)
Syntax LIST [ "program_name" ]
TYPE [ "program_name" ]
PROGRAMMING MANUAL
Description For use only with the Command Line Terminal interface. LIST is used as an
immediate (command line) command only and must not be used in programs.
The LIST command prints the current selected program or the program spec-
ified by program_name. The program name can also be specified without
quotes. If the program name is omitted, the current selected program will be
listed.
Note: This command is implemented for an offline Command Line Terminal.
Within Trajexia Studio users can use the terminal window.
Arguments • program_name
The program to be printed.
Example No example.
See also SELECT.
3.2.180 LIST_GLOBAL
/i
Type System command (terminal only)
Syntax LIST_GLOBAL
Description When executed from the Command Line Terminal interface (channel 0), all
the currently set GLOBAL and CONSTANT parameters will be printed to the
terminal.
Arguments N/A
Example In an application where the following GLOBAL and CONSTANT have been
set:
CONSTANT "cutter", 23
GLOBAL "conveyor",5
>>LIST_GLOBAL
Global VR
---------------- ----
conveyor 5
Constant Value
---------------- -------
cutter 23.0000
See also CONSTANT, GLOBAL
125