Omron CP1E - INTRODUCTION Introduction Manual page 143

PLC Setup
High-speed counter 0 will be enabled.
1.
Open the PLC Settings dialog box.
2.
Click the Built-in Input tab.
3.
Check the [Use high speed counter 0] checkbox for High Speed Counter
0.
4.
Select [Linear mode] for [Counting mode].
5.
Select [Software reset(comparing)] from the Reset drop-down list.
6.
Select [Differential phase input] from the Input Setting drop-down list.
7.
Close the PLC Settings dialog box.
8.
To apply changes made to the PLC settings, turn the PLC power ON.
A-4 CP1L Programming Examples
SYSMAC CP1L/CP1E Introduction Manual
A
141