Installation; Unpack The Pump - Graco G3-G-24MX-2L0L00-10CV00R0 Instructions Manual

Installation

Unpack the Pump

NOTICE
To prevent equipment damage, observe precautions
for handling electrostatic sensitive devices. Touch
ground before handling pump.
The pump module was carefully packaged for shipment
by Graco. When the package arrives, perform the fol-
lowing procedure to unpack the units:
1. Inspect the shipping box carefully for shipping
damage. Contact the carrier promptly if damage is
discovered.
2. Unseal the box and inspect the contents carefully.
There should not be any damaged parts.
3. Compare the packing slip against all items included
in the box. Any shortages or other inspection
problems should be reported immediately.
Choose an Installation Location
AUTOMATIC SYSTEM ACTIVATION HAZARD
The system is equipped with an automatic timer that
activates the pump lubrication system when power
is connected or when exiting the programming func-
tion. Unexpected activation of the system could
result in serious injury, including skin injection and
amputation.
Before you install or remove the lubrication pump
from the system, disconnect and isolate all power
supplies and relieve all pressure.
• Select a location that will adequately support
the weight of the G3 Pump and lubricant, as
well as all plumbing and electrical connections.
332305R
• Refer to the mounting hole layouts provided in
the Mounting Pattern section of this manual,
page 90. No other installation configuration
should be used.
• Use designated mounting holes and provided
configurations only.
• Always mount the G3 oil models upright.
• Mount top fill G3 pump models so that there is
a a minimum clearance of four inches (4.0 in.)
(10.2 cm) above the reservoir to allow for lid
removal and filling.
• If the G3 grease model is going to be operated
in a tilted or inverted position for any period of
time, you must use a model that includes a fol-
lower plate, otherwise the G3 must be mounted
upright. Refer to your model number to confirm
if a follower plate was installed on your pump.
See page 5, Understanding the Model Num-
ber to identify this character in your model
number.
• Use the three fasteners (included) to secure the
G3 to the mounting surface.
• Some installations may require an additional
reservoir support bracket. See table below for
bracket information.
• In high vibration environments, additional isola-
tion at mounting point is necessary. See table
below.
• AC pumps are not recommended when high
vibration or shock is present.
Part No Description
571159 Reservoir bracket and strap
125910 L-Bracket for pump
127665 USP to G-Series mounting bracket
132187 Isolator mounting kit
Installation
13