Dms ™ Models Only; Store Pump Program Settings To The Flash Drive41 - Graco G3-G-24MX-2L0L00-10CV00R0 Instructions Manual

2. OFF displays. If you
want the prelube
cycle to begin imme-
diately, leave this set
to OFF.
3. Press the ENTER button to set the
selection.
4. If you want to set a
prelube delay time,
press the DOWN
ARROW button to
change OFF to ON
on the display.
Prelube Delay
Prelube Delay can be entered to delay the start of the
pump's cycle on power up. If prelube is set to ON, a
prelube delay time in MM:SS must be entered. By
default, the delay is set to 0 (begin an ON cycle immedi-
ately).
Delaying the prelube function may be desired if other
critical functions or systems of your machine or vehicle
are also coming on line during power up.
1. Prelube Delay is set in
MM:SS (minutes and sec-
onds). To set the time use the
UP or DOWN ARROW button
to scroll through numerals 0
to 5 until the desired number
appears in the first MM (minutes) field.
The maximum length of time Prelube Delay can be
set to is 59:59 (59 minutes:59 seconds).
2. Press the ENTER button to lock in the
selection. The next MM number field to
the right flashes indicating it is ready for
programming.
3. Use the UP or DOWN
ARROW button to scroll
through numerals 0 to 9 until
the desired number appears
in the second MM number
field.
4. Press the ENTER button to lock in the
selection.
332305R
The next number field to the right flashes and the
LED lights under SS; indicating it is ready to pro-
gram the seconds fields.
5. Repeat steps 1 - 4 to set the SS (seconds) fields.
6. After pressing the ENTER button to set
the last SS field the G3 automatically
switches to the RUN MODE.
™
DMS Models Only
Download Data
1. Plug the USB flash drive into the USB port.
NOTE: The G3 pump stops pumping as soon as the
USB flash drive is plugged into it.
2. The system automatically begins downloading data
to the USB drive.
3. "data" is displayed while the system
is downloading files.
4. When download is finished, "done"
is displayed.
5. G3 pump resumes operation.
6. Remove the USB flash drive.
Store Pump Program Settings to
the Flash Drive
The pump program settings file is named either:
GRACO/G3Config/g3config.bin (for 0209 and earlier
versions) or GRACO/Config/config.bin (for 0706 and
later versions): This file cannot be modified. Modifica-
tion of the file or file name (by anyone but the issuer)
may cause it to be unusable.
1. Plug the USB flash drive into the USB port.
NOTE: The G3 pump stops pumping as soon as the
USB flash drive is plugged into it.
2. The system automatically begins downloading data
to the USB drive.
3. "data" is displayed while the system
is downloading files.
Max Model Setup
41