Fill The Oil Unit; Prime The Pump - Graco G3-G-24MX-2L0L00-10CV00R0 Instructions Manual

Remote Filling Station Pressure Relief
The reference letters used in the following instructions
refer to F . 6, page 12.
IG
The following Pressure Relief Procedure is only
used with the Auto-Fill Shut Off Valve to relieve
remote filling station and lubricant supply line
pressure.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from pressurized fluid, such as skin injection, splash-
ing fluid and moving parts, follow the Pressure Relief
Procedure when you stop dispensing and before
cleaning, checking, or servicing the equipment.
a. To relieve pressure between the Refill Pump (F)
and Auto-Fill Shut Off (B), open the Supply
Hose Pressure Relief Valve (Y) (F
sure will be released and excess fluid will drain
out of the drain tube (L) and into the lubrication
overflow container (W).
Y
F . 30
IG
b. Close Supply Hose Pressure Relief Valve (Y)
when all pressure has been relieved.
6. Disconnect the supply hose (J) from Quick Connect
(V).
332305R

Fill the Oil Unit

•
•
•
•
F
IG
. 30). Pres-
IG 1. Remove fill cap (a).
2. Pour oil into reservoir to max fill line (b).
3. Replace fill cap. Hand tighten cap, securely.5

Prime the Pump

NOTE: It is not necessary to prime pump every time
pump is filled with lubricant.
Pump only requires priming the first time it is used or if
it is allowed to run dry.
1. Loosen pump element fitting (F
L
NOTE: When loosening pump element fitting, do NOT
loosen pump element. Loosening pump element will
change the output volume.
W
Only use oil appropriate for your application, auto-
matic dispensing, and the equipment's operating
temperature. Consult with machine and lube manu-
facturer for details.
Do not overfill (F . 31).
IG
Do not operate G3 without reservoir attached.
Only use oils with viscosity at least 40 cSt.
. 31
Setup
a
b
. 32).
IG
29