Transceiver Removal; Base-Fx Fiber-Optic Port; Figure 14 Installed Transceiver; Figure 15 Opening The Transceiver's Latch Example - ZyXEL Communications Dimension ES-2108 User Manual

3 The switch automatically detects the installed transceiver. Check the LEDs to verify that
it is functioning properly.

Figure 14 Installed Transceiver

3.1.4.2 Transceiver Removal

Use the following steps to remove a mini GBIC transceiver (SFP module).
1 Open the transceiver's latch (latch styles vary).

Figure 15 Opening the Transceiver's Latch Example

2 Pull the transceiver out of the slot.

Figure 16 Transceiver Removal Example

3.1.5 100 Base-FX Fiber-Optic Port

This 100 Base-FX fiber-optic port is only available on the ES-2108-LC.
Note: To avoid possible eye injury, do not look directly into a module's fiber-optic
connectors. Keep the dust cover on a fiber-optic module until you connect it.
You may need to clean the fiber-optic cable's connectors with a cotton swab
dipped in alcohol.
• Type: Fiber-optic
• Wavelength: 1310 +/- 50 nm
• Multi-mode
• Dual LC connectors
• Connection distance: Up to 2km
Chapter 3 Hardware Overview
ES-2108 Series User's Guide
47