Setting Up Login Accounts; Figure 84 Access Control: Snmp; Table 56 Access Control: Snmp - ZyXEL Communications Dimension ES-2108 User Manual

ES-2108 Series User's Guide

Figure 84 Access Control: SNMP

The following table describes the labels in this screen.

Table 56 Access Control: SNMP

LABEL
Get Community
Set Community
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
Trap Destination
Apply
Cancel

23.4 Setting Up Login Accounts

Up to five people (one administrator and four non-administrators) may access the switch via
web configurator at any one time.
• An administrator is someone who can both view and configure switch changes. The
username for the Administrator is always admin. The default administrator password is
1234.
Note: It is highly recommended that you change the default administrator password
(1234).
• A non-administrator (username is something other than admin) is someone who can
view but not configure switch settings.
Click Access Control from the navigation panel and then click Logins from this screen.
154
DESCRIPTION
Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station.
Enter the set community, which is the password for incoming Set- requests from the
management station.
manager.
Enter the IP addresses of up to four stations to send your SNMP traps to.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 23 Access Control