Initial Screen; The Login Screen; Command Syntax Conventions - ZyXEL Communications Dimension ES-2108 User Manual

ES-2108 Series User's Guide

30.2.1.1 Initial Screen

When you turn on your switch, it performs several internal tests as well as line initialization.
You can view the initialization information using the console port. After the initialization, the
login screen displays (refer to
Copyright (c) 1994 - 2006 ZyXEL Communications Corp.
initialize mgmt, ethernet address: 00:13:49:00:00:01
initialize switch, ethernet address: 00:13:49:00:00:02
Initializing switch unit 0...
Initializing VLAN Database...
Initializing IP Interface...
Initializing Advanced Applications...
Initializing Command Line Interface...
Initializing Web Interface...
Press ENTER to continue...
Use the following steps to telnet into your switch.
1 Make sure your computer IP address and the switch IP address are on the same subnet.
2 In Windows, click Start (usually in the bottom left corner), Run and then type
192.168.0.1
3 A login screen displays (refer to

30.3 The Login Screen

After you have successfully established a connection to the switch using a direct console
connection or Telnet, a login screen displays as shown below. For your first login, enter the
default administrator login username "admin" and password "1234".

30.4 Command Syntax Conventions

The rules of the commands are listed next.
• The command keywords are in
• The required fields in a command are enclosed in angle brackets <>, for instance,
means that you must specify an IP number for this command.
<ip>
• The optional fields in a command are enclosed in square brackets [], for instance,
configure snmp-server [contact <system contact>] [location <system
location>]
means that the contact and location fields are optional.
184
Section 30.3 on page
(the default management IP address) and click OK.
Section 30.3 on page
Enter User Name : admin
Enter Password : XXXX
courier new font
184).
184).
.
Chapter 30 Introducing Commands
telnet
ping