Figure 67 Mvr: Group Configuration; Table 45 Mvr: Group Configuration - ZyXEL Communications Dimension ES-2108 User Manual

ES-2108 Series User's Guide

Figure 67 MVR: Group Configuration

The following table describes the labels in this screen.

Table 45 MVR: Group Configuration

LABEL
Multicast
VLAN ID
Name
Start Address
End Address
Add
Cancel
MVLAN
Name
Start Address
End Address
Delete ALL
Delete
Cancel
136
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-
down list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted decimal
notation.
Refer to Section 19.1.1 on page 127
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one
IP address for a multicast group.
Refer to Section 19.1.1 on page 127
Click Add to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Select Delete All and click Delete to remove all entries from the table.
Select Delete Group and click Delete to remove the selected entry(ies) from the table.
Select Cancel to clear the checkbox(es) in the table.
for more information on IP multicast addresses.
for more information on IP multicast addresses.
Chapter 19 Multicast