Resetting Commands; Re-Enable Commands; Other Examples Of No Commands - ZyXEL Communications Dimension ES-2108 User Manual

32.4.2 Resetting Commands

Use the
no
Syntax:
no https timeout
Resets the https session timeout to default.
An example is shown next. The session timeout is reset to 300 seconds.
sysname(config)# no https timeout
Cache timeout 300

32.4.3 Re-enable commands

The no command can also be used to re-enable features which have been disabled.
Syntax:
no ip route <ip> <mask> inactive
where
<ip> <mask> inactive
An example is shown next.
• Enable the IP route with the IP address of 192.168.11.1 and subnet mask of
255.255.255.0. This ip route must have already been created and made inactive prior to
re-enable command being applied.
sysname(config)# no ip route 192.168.11.1 255.255.255.0 inactive

32.4.4 Other Examples of no Commands

In some cases the
feature on a port by port basis.
Chapter 32 Configuration Mode Commands
command to reset switch settings to their default values.
= Re-enables an ip route with the specified IP address and
subnet mask.
command can disable a feature, disable an option of a feature or disable a
no
ES-2108 Series User's Guide
223