Configuration Mode Commands; Enabling Igmp Snooping - ZyXEL Communications Dimension ES-2108 User Manual

Configuration Mode Commands

This chapter describes how to enable and configure your switch's features using commands.
For more background information, see the feature specific chapters which proceed the
commands chapters.

32.1 Enabling IGMP Snooping

To enable IGMP snooping on the switch. Enter
can also set how to treat traffic from an unknown multicast group by typing the
multicast-frame
Syntax:
igmp-snooping
igmp-snooping host-timeout <1-16711450>
igmp-snooping leave-timeout <1-16711450>
igmp-snooping unknown multicast-frame <drop|flooding>
where
igmp-snooping
host-timeout <1-
16711450>
leave-timeout <1-
16711450>
igmp-snooping unknown
multicast-frame
<drop|flooding>
An example is shown next.
• Enable IGMP snooping on the switch.
• Set the
Chapter 32 Configuration Mode Commands
parameter.
= Enables IGMP snooping on the switch.
= Specifies the time out period of the switch with respect to
IGMP report queries. If an IGMP report for a multicast
group was not received for a host-timeout period, from a
specific port, this port is deleted from the member list of
that multicast group.
= Specifies the time that the switch will wait for multicast
members to respond to a leave report. If no response
happens in the timeout period, the switch deletes the port
from the multicast group.
= Specifies whether you want to discard packets from
unknown multicast groups or whether you want to forward
them to all ports.
and
host-timeout leave-timeout
ES-2108 Series User's Guide
C
H A P T E R
igmp-snooping
values to 30 seconds
3 2
and press [ENTER]. You
unknown-
219