Prestige 1400 WAN Router with Integrated Ethernet Switch
LED
PWR
The PWR (power) LED is on when power is applied to the Prestige.
SYS
The SYS (system) LED is on when the system is running normally and is off when the
system is not ready or has failed. It blinks when the system is rebooting.
1-16
A port LED is on when the link for its corresponding integrated switch port is up and
blinks when data is being transmitted or received.
RDY/ACT
The RDY/ACT LED is on when the link between the WAN port and a WAN device is up
and ready. The LED blinks to indicate activity when the WAN port is transmitting data.
LAN
The LAN port is for connecting the Prestige routing module to an Ethernet network.
The amber LED is on when the link speed is 100 Mbps and the green LED indicates
10 Mbps. The LED blinks when the port is transmitting data.
3.6
Initial Screen
When you power on your Prestige, the router performs several internal tests and initializes the ports. After the
initialization, the Prestige asks you to press [ENTER] to continue, as shown below:
3.6.1
Password
After you press [ENTER], the Login screen appears prompting you to enter the password, as shown in the next
figure.
For your first login, enter the default password 1234. As you enter the password, the screen displays an (X) for
each character you type.
3-4
Figure 3-3 Front Panel LEDs
Table 3-1 Front Panel LEDs
Copyright (c) 2001 ZyXEL Communications Corp.
ethernet address: 00:a0:c5:00:50:02
Press ENTER to continue...
Figure 3-4 Power-On Display
Enter Password : XXXX
Figure 3-5 Login Screen
DESCRIPTION
Hardware Installation & Initial Setup