Error Codes - Lincoln Electric FlexCut 200 Service Manual

LINCOLN ELECTRIC

Error Codes

Observe Safety Guidelines
detailed in the beginning of this manual.
ERROR CODE POSSIBLE CAUSE
Communication error between
power board and control
board.
Work Transfer failed.
Pilot timer error.
No pilot arc could be
established.
FlexCut® 200 Service Manual
ERROR CODES
RECOMMENDED
COURSE OF ACTION
Cycle power to the machine to
see if error clears. Otherwise a
qualified technician must check
communication between the
power and control boards.
In cut, mark, and grid modes,
the pilot arc will only run for 5
seconds to prevent
unnecessary consumable wear.
Verify the correct torch to
workpiece height and that the
work lead is connected and
making a good electrical
connection.
In cut, mark and grid modes,
the pilot arc will only run for
five seconds to prevent
unnecessary consumable wear.
Verify the correct torch to work
piece height and that the work
lead is connected and making a
good electrical connection.
If error occurs immediately
after triggering, verify correct
three phase input.
Check that all leads are
properly connected between
the power source, FlexCut and
torch. Verify that the
consumables are correctly
installed.
10