Test Procedures; Case Cover Removal And Replacement Procedure - Lincoln Electric FlexCut 200 Service Manual

LINCOLN ELECTRIC

Test Procedures

CASE COVER REMOVAL AND REPLACEMENT PROCEDURE

Service and repair should be performed by only Lincoln Electric factory trained personnel. Unauthorized
repairs performed on this equipment may result in danger to the technician or machine operator and will
invalidate your factory warranty. For your safety and to avoid electrical shock, please observe all safety
notes and precautions detailed throughout this manual. If for any reason you do not understand the test
procedures or are unable to perform the test/repairs safely, contact the Lincoln Electric Service Department
for electrical troubleshooting assistance before you proceed. Call 1-888-935-3877.
TEST DESCRIPTION
This procedure will aid the technician in the removal and replacement of the Case Covers.
MATERIALS NEEDED
5/16" Nutdriver
REMOVAL PROCEDURE
1. Carefully remove input power from the FlexCut 200 machine.
2. Carefully unscrew the two eyebolts from the top of the machine. See Figure F.1.
3. Using a 5/16" nutdriver, remove the four screws from the top of the roof. See Figure F.1.
4. Using a 5/16" nutdriver, remove the six longer screws from the sides of the roof. See Figure F.1.
5. Carefully remove the roof panel.
6. Using a 5/16" nutdriver, remove the four screws securing the right case side panel. See Figure F.2.
7. Carefully remove the right case side panel.
8. Using a 5/16" nutdriver, remove the four screws securing the left case side panel. See Figure F.2.
9. Carefully remove the left case side panel.
10. Perform any tests / replacement procedure.
REPLACEMENT PROCEDURE
1. Position the left case side panel onto the machine.
2. Using a 5/16" nutdriver, attach the four screws securing the left case side panel.
3. Position the right case side panel onto the machine.
4. Using a 5/16" nutdriver, attach the four screws securing the right case side panel.
5. Position the roof panel onto the machine.
6. Using a 5/16" nutdriver, attach the six longer screws to the sides of the roof.
7. Using a 5/16" nutdriver, attach the four screws to the top of the roof.
8. Carefully screw the two eyebolts into the top of the machine.
FlexCut® 200 Service Manual
15