Lincoln Electric FlexCut 200 Service Manual page 108

LINCOLN ELECTRIC
3. Using a Phillips screwdriver, attach the two screws and lock washers securing solenoid 3 to the
vertical divider panel.
4. Using a 1/4" nutdriver, attach the two mounting nuts, lock washers and flat washers securing
solenoid 3 to the vertical divider panel.
5. Carefully position the new solenoids 1 and 2 together, use solenoid spacers between the two
solenoids and between the solenoids and upper shelf.
6. Using a Phillips screwdriver, attach the two screws and lock washers securing solenoids 1 and 2 to
each other.
7. Using a 1/4" nutdriver, attach the two mounting nuts, lock washers and flat washers securing the
solenoids to the vertical divider panel.
8. Connect the seven previously disconnected hoses to the solenoids 1, 2 and 3. See Wiring Diagram.
9. Perform the Case Cover Replacement
10. Perform the Retest After Repair Procedure.
Procedure.
Figure F.78 – Solenoid hose locations
FlexCut® 200 Service Manual
103