Voltage Divider Board Removal And Replacement Procedure - Lincoln Electric FlexCut 200 Service Manual

LINCOLN ELECTRIC

VOLTAGE DIVIDER BOARD REMOVAL AND REPLACEMENT PROCEDURE

Service and repair should be performed by only Lincoln Electric factory trained personnel. Unauthorized
repairs performed on this equipment may result in danger to the technician or machine operator and will
invalidate your factory warranty. For your safety and to avoid electrical shock, please observe all safety
notes and precautions detailed throughout this manual. If for any reason you do not understand the test
procedures or are unable to perform the test/repairs safely, contact the Lincoln Electric Service Department
for electrical troubleshooting assistance before you proceed. Call 1-888-935-3877.
TEST DESCRIPTION
This procedure will aid the technician in the removal and replacement of the
MATERIALS NEEDED
Wiring Diagram
REMOVAL PROCEDURE
1. Carefully remove input power from the FlexCut 200 machine.
2. Perform the Case Cover Removal Procedure.
3. Perform the Capacitor Discharge Procedure.
4. Label and disconnect plugs J1, J2 and J3 (if necessary) from the voltage divider board. See Figure
F.83. See Wiring Diagram.
5. Carefully pry the voltage divider board off the mounting posts. See Figure F.84.
6. The voltage divider board
REPLACEMENT PROCEDURE
1. Carefully position the new voltage divider board into the machine and press onto the mounting
posts.
2. Connect plugs J1, J2 and J3 (if necessary) to the voltage divider board. See Wiring
3. Perform the Case Cover Replacement
4. Perform the Retest After Repair Procedure.
can now be removed and replaced.
Procedure.
FlexCut® 200 Service Manual
Voltage Divider Board.
Diagram.
108