Lincoln Electric FlexCut 200 Service Manual page 85

LINCOLN ELECTRIC
4. Connect leads 207, 209, L1A, L1B, L2A, L3A and H1 to the input rectifier (D1). See Wiring Diagram.
5. Using a 5/16" nutdriver, attach the five screws, lock washers and flat washers securing the leads to
the input rectifier (D1). See Wiring Diagram.
6. Apply a heavy coating of silicone sealant to protect the lead connection points.
7. Perform the Case Cover Replacement
8. Perform the Retest After Repair Procedure.
Figure F.56 – Input rectifier (D1) lead locations
Figure F.57 – Input rectifier (D1) mounting hardware locations
Procedure.
FlexCut® 200 Service Manual
80