3359 Pivot Block and Yoke
Removal
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Remove the print head (3351).
4.
Remove the solenoid assembly (3360).
5.
Remove the solenoid standoff stud
O.
6.
Remove the pivot blocks
e
and the yoke assem-
bly
G
by removing the two screws
G
and pulling
the yoke assembly forward.
Pivot
block
(2)
Pivot
b
block
(2)
Bushing
Top view
block
(2)
d
Pivot
Reinstallation
1.
Place the bushing
e
and the pivot block
e
on
the left side of the yoke.
2.
Place the washer
G
and the pivot block
e
on the
right side of the yoke.
3.
Hold the unit together and slip the two pivot
blocks into the carrier mounting holes (Ensure
that pin. is in the opening in the carrier.).
4.
Reinstall the screws
G
and ensure that the yoke
pivots freely.
5.
Reinstall the solenoid standoff stud
O.
6.
Reinstall the solenoid assembly (3360).
7.
Reinstall the print head (3351).
8.
Reinstall the top cover (3052).
I
/
Maintenance Procedures
3-71