Table of Contents
Advertisement
3101 Platen and Paper Deflector
Removal
1.
Switch off the printer power.
2.
Remove the forms tractor (3151).
3.
Remove the access cover (3051).
4.
Move the print head to the center of the platen
with your hand.
5.
Lift both paper-advance knobs
e
while pressing
down on both platen release levers
O.
6.
Remove the platen.
7.
The paper deflector
0
may now be lifted out.
3-8
SY34-0613
Reinstallation
1.
Reinstall the paper deflector by placing it with the
openings toward the front, ensuring that the slot-
ted tabs
e
on the bottom of the deflector engage
the locators
G
at each end.
2.
Reinstall the platen as follows:
a.
Set the paper-release lever
G)
to the forward
position.
b.
Ensure that the paper deflector
0
is seated
correctly, with the tabs
e
engaging the loca-
tors
G.
Note: The locators may need adjusting.
Refer to "3105 Platen Locator Tabs."
c.
Move the print head to the center of the
platen with your hand.
d.
Align the groove
0
in the gear end of the
platen shaft with the right side frame. Then,
press down on both ends of the platen, ensur-
ing that the gears mesh correctly.
e.
Ensure that the platen release levers
0
are
completely seated.
f.
Move the paper-release lever
G)
to the rear
position.
3.
Reinstall the access cover (3051).
4.
Reinstall the forms tractor (3151).
Advertisement
Table of Contents
