3358 Print Head Retract R.amp
Adjustment
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Set the copy-control dial
0
to
o.
Printer in service position
Note: This adjustment is only valid for sheet metal
ramp.
4.
Form the retract ramp. so that the copy-control
dial is 2.41±0.13 mm (0.095±0.005 in.) from the
print head. Use a code plate alignment tool (part
460028), as shown, at. to measure this distance.
5.
Reinstall the top cover (3052).
2.41 ± 0.13
mT
(0.095 ± 0.005 in.)
Print head
(top view)
Code plate alignment tool,
PIN
460028
Maintenance Procedures
3-69