Table of Contents
Advertisement
3052 Top Cover
Removal
1.
Switch off the printer power.
2.
Remove the forms tractor (3151).
3.
Remove the access cover (3051).
4.
Remove the platen (3101).
5.
Remove the horizontal adjustment knob.
6.
Move the paper-release lever
G
toward the front
of the printer.
7.
Set the mode switch
0
to the Wait position.
8.
Using a screwdriver as shown at
G,
slide the right
and left cover-latch brackets to the front to
release the cover.
9.
Lift the top cover off.
3-2
SY34-0613
Reinstallation
1.
Ensure that the paper-release lever is in the
forward position.
2.
Ensure that the mode switch
G
is in the straight
up position.
3.
Lower the top cover over the printer until the
cover engages the base molding. The cover is
self-aligning and only fits one way.
4.
Using a screwdriver as shown at
0,
slide the right
and left cover-latch brackets toward the rear until
they are tightly under the cover latch springs.
5.
Reinstall the horizontal adjustment knob.
6.
Reinstall the platen (3101).
7.
Reinstall the access cover (3051).
8.
Reinstall the forms tractor (3151).
Advertisement
Table of Contents
