3354
on
Felt
Removal
1.
Switch off the printer power.
2.
Remove the access cover (3051).
3.
Remove the ribbon cartridge (3405).
4.
Remove the print head cover (two screws) • .
5.
Pull the oil wick out of the print head tip
e.
6.
Lift the oil wick out of the oil wick holder
G.
Print
Felt
Reinstallatioll
1.
Reinstall the oil wic,k in the oil wick holder
O.
2.
Saturate the oil wick with IBM No. 6 oil and place
it in the print head tip
e.
Note:
If
a oil felt holder is being installed, lubri-
cate the felt as described in "Oil Felt Lubrication"
in Chapter 5.
3.
Reinstall the print head cover (two screws) • .
4.
Reinstall the ribbon cartridge (3405).
5.
Reinstall the access cover (3051).
:~1ires
6'
Install f;lt pad between
J
oil wick knot and
_
Wick
plastic tubing
clip
Oil felt
h~~o:ld:e;r~~~~~=+...4~-....L
Maintenance Procedures 3-63