Table of Contents
Advertisement
3458 Resistor Assembly
Removal
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Remove the logic/control board (3501).
4.
Remove the resistor assembly mounting screw
O.
5.
Slide the assembly forward and to the left until it
is free from the three mountings. on the base.
Reinstallation
1.
Slide the resistor assembly to the rear and to the
right until it is positioned within the three mount-
ings • on the base.
2.
Reinstall the assembly mounting screw
O.
3.
Reinstall the logic/control board (3501).
4.
Reinstall the top cover (3052).
Maintenance Procedures
3-99
Advertisement
Table of Contents
