3305 Carrier Belt Tensioner
Removal
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Loosen the carrier-to-belt clamp
8;
slip the belt
out of the clamp.
4.
Remove the belt from the motor pUlley.
5.
Remove the screw
0
and the belt tensioner
assemblye·
Belt tensioner assembly
Drive belt
Printer shown in service position
3-52
SY34-0613
Reinstallation
1.
Reinstall the belt tensioner but do not tighten the
screw
0
completely.
2.
Reinstall the belt on the motor pulley.
3.
Slip the belt into the carrier-to-belt clamp.
4.
Move the belt tensioner as shown by the arrows,
so that the drive belt. is aligned with the carrier
bracket.
5.
Tighten the clamp
8
and screw
O.
6.
Restore the printer to the operating position
(3053).
7.
Reinstall the top cover (3052).