Table of Contents
Advertisement
3252
Print
Emitter Pickup
Removal
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Place the printer in the service position (3053).
4.
Disconnect P10A from JIOA . , and PIOB from
JIOBO·
5.
Remove the two screws
E)
that hold the emitter
pickup and the clamp to the carrier; do not lose
the spring at
e.
Reinstallation
1.
Ensure that the coil spring is located between the
emitter pickup and the clamp at
e;
then install
the two screws
E).
2.
Connect P 1 OA and P 10B, as shown.
3.
Perform the print-emitter to print-emitter pickup
adjustment (3253).
Maintenance Procedures 3-41
Advertisement
Table of Contents
