3053 Placing the Printer in the Service Position
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Remove the logic/control board safety cover
(3502).
4.
Remove the print head cable clamp
0
and
disconnect print cable connector P4
e.
5.
Disconnect:
a.
Forms feed emitter cable connector P9
e.
b.
Motor cable connectors P5
0
and P7
O·
c.
End-of-forms/print emitter cable connector
P8G·
6.
Remove the base screws
e
on the right end of the
printer.
7.
Loosen the base screws • on the left end of the
printer.
8.
Remove the paper deflector (3101).
9.
Slide the printer to the right to clear the screws
• and lift the printer from the printer base.
10. Place the printer into the service position on the
base, and hold the printer in this position by
installing a base screw • on the left side and a
base screw
e
on the right side.
3-4
SY34-0613