Table of Contents
Advertisement
Removal
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Remove the ribbon cartridge (3405).
4.
Remove the print head (3351).
5.
Place the printer in the service position (3053).
6.
Remove the belt clamp
G.
7.
Remove the print emitter pickup (3252)
e.
8.
Unwind the ribbon drive cords from the drive
clutches; do not disconnect the springs attached to
the side frames.
9.
Remove the screws
4)
from each end of the carri-
er main shaft.
10. Loosen the screws
0
in the ends of the carrier
support shaft. Pull the side frames apart enough
to release the main shaft.
11. Pivot the carrier and main shaft around the carrier
support shaft to clear the A-frame
G).
12. Remove the carrier and the shaft.
13. Remove the ribbon drive assembly (3401) from
the carrier.
3-46
SY34-0613
Advertisement
Table of Contents
