Table of Contents
Advertisement
Macro Driver
b1slllaliJ1
Page 8-12
The message shown below is displayed on your monitor
to indicate the keyboard driver with macro capability has
been loaded.
Key Tronic extended keyboard driver
Copyright Key Tronic Corp. 1991
Macro support
Ver. I.I U.K.
'.\1aximum ** 32 macros **each 32 bytes long
\!aero filename not found
The last line of the message shown above. '"Macro
filename not found:· is displayed because the driver is
looking for a user-defined macro file. For example. if you
entered. MC102l!K FILENAME.KEM. this line would
not be displayed. Loading user-defined macro files
automatically with the keyboard macro driver is discussed
in detail later in this section. Loading the keyboard macro
driver without a user-defined macro. as shown above. does
not affect the operation of the keyboard macro driver.
Fallow these steps for floppy disk systems:
Step 1.
Place the \vork copy of the Key Tronic
Software Disk into either drive and enter the
name of the keyboard macro driver. To load
the UK keyboard macro driver. type the
following from the DOS prompt:
MCJ02UK <Return>
The same message shown above will be displayed to
indicate the keyboard macro driver is loaded.
Advertisement
Table of Contents
