User's Manual
Chapter 4 Applications
This chapter provides detailed information on using the UT8806E to make electrical
measurements.
Example 1 Reading Statistics
Example 2 Eliminate Test Lead Impedance Error
Example 3 dBm Measurement
Example 4 dB Measurement
Example 5 Limits Measurement
Example 6 Hold Measurement
Example 7 Thermocouple Setting and Measurement
Example 1 Reading Statistics
This section describes how to realize reading statistics in measurement. The multimeter is
constantly updating the statistic when multiple readings are measured consecutively.
Operation Steps
1.
Press the
appropriate voltage scale.
2. Connect one end of the test lead to the multimeter, the red test lead to the Input-HI
terminal and the black test lead to the Input-LO terminal, as shown in Figure 2-11.
3. Set the parameter for statistics operation.
Press
maximum and minimum value.
4. Connect the test leads into the circuit and start the measurement.
As Figure 0–70 and Figure 0–71, the statistical values are constantly updated as the
number of samples increases.
Instruments.uni-trend.com
key on the front panel to turn on DC voltage measurement and select the
→ [Statistics] →[ON] to turn on the statistics operation to count the
UT8806E Desktop Digital Multimeter
82 / 104