Table of Contents
Advertisement
User's Manual
7. Mathematical operation
The user can perform mathematical operations (statistic, limit, relative) on measurement
readings. For details on how to use this function, refer to the section "Mathematical
Operation Function" in this chapter.
8. Graphical display
The user can change the display mode of the measured data through [Display], and there
are four display modes, "Digital", "Bar", "Tendency" and "Histogram" figures. Please refer to
the section "Display Mode" for details.
Continuity Measurement
The continuity test measures the resistance of the circuit under test with a current of
approximately 1mA by using the 2-wire method and determines whether the circuit is
complete. When the measured resistance value in the short-circuit test circuit is lower than
the set short-circuit resistance, the instrument determines that the circuit is connected and
the beeper emits a continuous beep (if the beeper is turned on). The following section
describes how to use the UT8806E multimeter to perform a continuity test on a circuit.
Test Steps
1. Press the
shown in Figure 2-30.
2. As shown in Figure 0–31, connect the test leads to the signal to be measured, the red test
lead to the "Input-HI" terminal and the black test lead to the "Input-LO" terminal.
Instruments.uni-trend.com
key on the front panel to enter the continuity measurement menu, as
Figure 0–34 Continuity Measurement Menu
UT8806E Desktop Digital Multimeter
41 / 104
Advertisement
Table of Contents
