Range Selecting - UNI-T UT8806E User Manual

User's Manual
The default measurement configuration of the multimeter ensures accurate measurement
results in most cases. The user can directly carry out any measurement operation or modify
the measurement parameters under various measurement functions as needed.
Different parameters can be set for different measurement functions, please refer to the
following table.
Table 0-1 Measurment Parameter
Measurement Function
DCV
ACV
DCI
ACI
OHM (2WR, 4WR)
CAP
CONT
DIODE
FREQ/PREIOD
TEMP

Range Selecting

There are two ways to select the range, automatic and manual. The multimeter can
automatically select the appropriate range based on the input signal, so that the input value
can between 10% and 110% of the range, which is very convenient for the user. The user can
also select the range manually to get faster readings and more appropriate measurements.
The range selection key is located on the right side of the front panel, as shown in Figure 2-1.
Instruments.uni-trend.com
Configuration Parameter
Range, integral time, input impedance, automatic
zeroing
Range, low-frequency filter
Range, integral time, automatic zeroing
Range, low-frequency filter
Range, integral time, automatic zeroing, offset
compensation (OC)
Range
Short-circuit resistance
Diode break-over voltage
Measuring interval
Probe selection, measurement mode
UT8806E Desktop Digital Multimeter
11 / 104