Pushing or Towing the Machine (continued)
Do not pump the manifold after it does not pump easily. Damage could occur if the
manifold is pumped too much.
Note:
approximately 60 minutes. If needed after 60 minutes, release the brake again by
pumping the manifold.
6. Push or tow the machine.
7. Set the brake by pulling the black knob out or starting the engine.
Note:
8. Close the bypass valves. Torque the valves to 11 N∙m (5 to 8 ft-lb).
Ensure that the bypass valves are closed before you start operating the machine.
Running the engine with an open bypass valve causes the transmission to overheat.
3464-478A
Once the pressure is built up in the manifold, the brake will be released for
The brake automatically resets when you start the engine.
IMPORTANT
IMPORTANT
Page 5–32
Operation: After Operation