Toro Reelmaster 5010-H Operator's Manual page 60

Overview of the InfoCenter Display (continued)
7. After you select Y
selections.
Setting the Blade Count
1. In Machine Settings, scroll down to Blade Count.
2. Press the right navigation button to change the blade count between 8 or 11 blade reels.
Setting the Height of Cut (HOC)
1. In Machine Settings, scroll down to Height of Cut.
2. Use the left and right navigation buttons to select the HOC setting that matches the
bench setting of the cutting units. If the exact setting is not displayed, select the nearest
HOC setting from the list displayed.
Setting the Front and Rear Reel Speeds
1. With Clip Control O
decrease proportional to the traction speed the operator commands.
2. With Clip Control O
speed.
Note:
Additionally, the front and rear reel speeds can be manually adjusted in Machine
Settings.
Setting the Economy Mode
Operating in economy mode can be beneficial in light-duty or noise-sensitive applications.
The working speed of the engine is reduced, but traction and reel speeds are not.
Note:
Mow speeds over 8.6 km/h (5.5 mph) are not recommended in economy mode.
1. From the Main Menu, scroll down to Machine Settings and press the select button.
2. In Machine Settings, scroll down to Eco Mode.
3. Press the right navigation button to turn it O
Setting the Maximum Allowed Mow Speed
The selected setting is displayed as an X on the traction-speed bar graph along with the
cruise control and pedal stop settings. An X in a bar denotes that the maximum speed is
limited by the supervisor.
Note:
This setting is retained in memory and applied to the traction speed until you change
it.
1. In Machine Settings, scroll down to Mow Speed.
Operation: Before Operation
, the interval screen clears and reverts back to the service hours
ES
(default), the speed of the reels will dynamically increase or
N
, a static reel speed is set relative to the supervisor max mow
FF
Page 5–13
.
N
3464-478 A